Common Type-Based, Structural BMPs for Industrial Sector A
Point BMP
Constructed Wetland
Infiltration Basin
Bioretention
Sand Filter (surface)
Rain Barrel
Cistern
Wet Pond
Dry Pond
Linear BMP
Grassed Swale
Infiltration Trench
Vegetated Filter Strip
Sand Filter (non-surface)
Area BMP
Green Roof
Porous Pavement
Common Pollutant Sources for Industrial Sector A:
Exposure of lumber, residues, and vehicles/equipment to precipitation
Parts cleaning
Waste disposal of oily rags, oil and gas filters, batteries, coolants, degreasers
Fluid replacement including hydraulic fluid, oil, transmission fluid, radiator fluids, and grease
Diesel fuel
Common Toxicants for Industrial Sector A
Nutrients
nitrates
Pesticides
2,4-D γ -BHC (lindane)
malathion
atrazine
chlordane
diazinon
Other organics
VOCs
1,3-dichloro-benzene
anthracene
benzo(a) anthracene
benzo(b) fluoranthene
benzo(k) fluoranthene
benzo(a) pyrene
bis (2-ethylhexyl) phthalate
fluoranthene
fluorene
naphthalene
pentachlorophenol
phenanthrene
pyrene
Pathogens
enteroviruses
Shigella
Pseudomonas aeruginosa
protozoa
Heavy Metals
nickel
cadmium
chromium
lead
zinc
copper
Salts
chloride
Common Pollutants for Industrial Sector A:
BOD, TSS, oil, and grease
Solvents, oil, heavy metals, acid/alkaline wastes
Oil, heavy metals, solvents, acids
Oil and grease, arsenic, lead, cadmium, chromium, COD, and benzene
Diesel, gasoline, oil
Factors that can affect water quality:
Geographic location
Hydrogeology
Topography
Type, duration, and intensity of precipitation events
Extent of impervious surfaces (e.g., concrete or asphalt)
Type of ground cover (e.g., vegetation, crushed stone, or dirt)
Size of the operation
This site focuses or refers to information and services regarding Qualifying Storm Event (QSE) Sedimentation Third Party Environmental Group (TPEG) Clean Water Act (CWA) Regional Water Board Monitoring Requirements Waste Discharge Identification Number (WDID) Stormwater Discharge Points Debris Straw Wattles Chain of Custody Standard Industrial Classification (SIC) No Exposure Certification (NEC) Erosion Effective Date Scheduled Facility Operating Hours Run-on National Pollutant Discharge Elimination System (NPDES) Plastic Materials Biochemical Oxygen Demand (BOD) Storm Water Multiple Application and Report Tracking System (SMARTS) Numeric Action Level (NAL) Division of Water Quality (DWQ) Municipal Separate Storm Sewer System (MS4) Ontario Storm Wattles Permit Registration Documents (PRDs) Areas of Special Biological Significance (ASBS) State water Board Stormwater Notice of Non Applicability (NONA) Method Detection Limit Trade Secret Erosion Control BMPs Storm Water Discharge Associated with Industrial Activity Numeric Action Level (NAL) Exceedance Structural Controls Facility North American Industrial Classification System (NAICS) Industrial General Permit (IGP) New Source Performance Standards (NSPS) Discharger Operator Total Organic Carbon (TOC) Stormwater Permit Monitoring Implementation Plan Third Party Environmental Lawsuit (TPEL) Source Effluent Quality Assurance/Quality Control (QA/QC) Best Conventional Pollutant Control Technology (BCT) Runoff Control BMPs Numeric Effluent Limitation (NEL) Non stormwater Total Suspended Solids (TSS) Toxicity United States Environmental Protection Agency (U.S. EPA) Effluent Limitations Guidelines (ELGs) Field Measurements Stormwater Guarantee Industrial Materials Storm wattle Flocculant Socks Best Available Technology Economically Achievable (BAT) New Discharge(r) Detected Not Quantifiable State Water Resources Control Board (SWRCB) Notice of Termination (NOT) Storm Water Pollution Prevention Plan (SWPPP) Non-Governmental Organization (NGO) Best Management Practices (BMP) pH Storm Water Systems (SWS) Waters of the United States Industrial Storm wattles Wattle Minimum Level Sediment Water Quality Objectives Best Practicable Control Technology Currently Available (BPT) New Industrial General Permit New Source Performance Standards Turbidity Southern Industrial Sector A Timber Products Facilities Qualified Industrial Storm water Practitioner (QISP) Legally Responsible Person (LRP) Oil and Grease (O&G) Effluent Limitation Scrap Metal Permit Water Quality Standards Good Housekeeping BMPs Stormwater Benchmarks Stormwater Drainage Northern Industrial Sector A Timber Products Facilities Water Quality Based Effluent Limitation (WQBEL) Multi Sector General Permit (MSGP) Natural Background Sediment Control BMPs Non Storm Water Discharges (NSWD) Drainage Area Exceedance Response Action (ERA) Technology Based Effluent Limitation (TBEL) Sheet Flow Non Detect Wattles Total Dissolved Solids (TDS) Total Maximum Daily Load (TMDL) Notice of Intent (NOI) and more.
In addition, stormwater benchmarks non-stormwater observation stormwater engineer services stormwater consultant stormwater expert consultation stormwater osha safety and health inspection oil solidifying booms stormwater vessels non-stormwater observation report swppp oil solidifying pillows stormwater annual report plastic inlet filter stormwater safety inspection plan health and safety consultation stormwater management services stormwater filtration media stormwater hmbp Industrial Sector A Timber Products Facilities stormwater environmental stormwater quarterly observation stormwater osha stormwater regulations penalties united states stormwater oil sheen sock stormwater runoff sampling stormwater sampling Industrial Sector A Timber Products Facilities stormwater treatment stormwater expert witness Industrial Sector A Timber Products Facilities stormwater news Industrial Sector A Timber Products Facilities industrial wattle stormwater compliance audit stormwater discharge stormwater rain information stormwater sand filters stormwater regulations Industrial Sector A Timber Products Facilities environmental management stormwater plan of action stormwater observation report stormwater record keeping stormwater hazardous materials business plan Industrial Sector A Timber Products Facilities stormwater mechanical filtration and more.